-
As the microcontroller kinda requires 2.7V and the low audio volume in V1.1, why not make a LIR2032 only version with a cheap lipo charger/protection circuit with USB input?
-
The PMID pin of the BQ25895M chip provides the boosted output providing the OTG pin is high and Vbus is disconnected.
So with an input at the usb port the device will provide power management to us…
-
Hi there!
Thanks a lot for this documentation, it has been helpful to start tinkering with my opel corsa-e and home assistant!
Trying to keep things as tidy as possible in my home assistant config…
-
To implement solar charger logic using BLE, it would be helpful to know if a charging cable is plugged in and if the battery currently needs charge. (Reading the SOC via BLE also would be nice to impl…
-
-
**Describe the bug**
In the documentation, the multi-port EV "advanced example" has unreasonable peak values, >20MW for 5 EVs, even
**What is the expected behavior?**
Consider that Tesla DCFC ch…
-
I saw in few places users requesting wired connection between split halves of some keyboards using ZMK firmware (like Advantage360 Pro or Glove80) and developers said that it is not supported by ZMK f…
-
D4 is dimly lit when Jasmine is charging with load switch SW1 turned off. This happens when charging from Azalea's USB port but not when charging from Jasmine's USB port. I assume this is due to rev…
-
In many cases there are multiple charging stations at a site. A "site" should be precisely defined, but is loosely defined as a parking facility or a section of street-side parking where charging sta…
-
Amd b550, Win10, nsw lite. DBI mtp responder not working with type-c connection to type-c mb port. Using fully working tested cable. Same pc usb-a cable works fine. Is it dbi bug or pc drivers problem…