-
I seem to be getting some noise on my sensor and I get very extreme values when this happens. These readings are usually over 100,000 W up to over 1 million some times.
I have found a lambda filler…
-
Good Morning all,
Would it be possible for someone to add a page to the Wiki that explains the correct way to wire NC limit switches. maybe with a schematic drawn up. I have been confused about this …
-
My bot generally works fairly well, but my probe isn't very accurate, at least I don't think so (in the M48 repeatability test, I get a standard deviation of as low as about 0.0015 to as high as about…
-
After upgrading and flashing up to BuF 3.5.0 now only motor #1 is spinning.
From time to time motor 3 will "bulb/shake" a little.
Done full chip erase while flashing via GUI, always do.
hglrc f…
-
Customer (Lars F., Matthijs' contact) is reporting that adaptive brightness on his Cerbo GX v3.40~10 is pulsating:
https://github.com/victronenergy/gui-v2/assets/5200296/3b185514-d072-4bdf-a23d-ca6…
-
Hello
I am working on a project; using mpu9250 on stm32f4 discovery board. I have two issues with the device and will be pleased if some one helps.
First;
I am trying to configure PWR_1 register and…
-
# Intro
I'm a Finnish tool & die maker by profession and use electrical discharge machines (EDM's) almost daily at work. On my free time I do machining as a hobby and use the machines at work to buil…
-
In this issue, I propose to discuss the best way to implement gyro functionality
-
Dear Marlin Devs,
This is a Feature Request to allow a Print to re-home once TMC2130 (and similar) detects a missed step (which is reported to the driver)
The idea is that when the TMC drivers …
-
Here are all the common difficulty algorithms. All equations are expressed as floating point to make the math clear. Typically, you expand the equations for target's really high value to reduce the e…