-
Hi There,
First off I wanted to thank you for this great project! From an outside perspective it was only on my second or third pass poking around that I found the thepaintbrush repo with the pcb …
-
(@mcous has taken over this post to elevate comment below):
New package proposal: `@tracespace/stats`. It think it could have the same signature as pcb-stackup or be included in pcb-stackup by defa…
-
## Tasks
## PCB
- [x] Move row 0 diodes (top row or F row) below their switches instead of above to keep them off the edge of the PCB
- [x] Move row 0 traces to be below the switch
## Plates
…
-
Hello and thank you very much for your work, honestly it's brilliant!
Since not many people have access to PCB manufacturing / KiCad skills or want to make something like a dactyl keyboard (my usec…
ghost updated
8 months ago
-
When ordering manufacturing of the Pro PCBs, I ran into some issues:
- the MX hotswap socket holes have a 0.1mm hole inside them which shouldn't be there (see screenshot)
- all footprints referenc…
-
### Discord Username
cooperlu0314
### Bug Summary
The backplate can't fit properly because of the LED pins and resistor on the top layer of the backlight PCB.
### Expected Results
The backplate a…
-
Hello! First of all, thank you so much for the work you've done on this, this looks like a very promising cheap and DIY way to program AVR microcontrollers, way smaller and lighter than my AVRISPMKII.…
-
It would like to be built up one 3d printer using your panel (REMPS-FD) this will be the third machine what I prepare. Unfortunately home manufacturing too thin the lines on the mucus sheet. I can buy…
-
The holes where the headers for the RP2040 Zero measure 0.762 mm in diameter (according to Kicad). It seems that some square-y pins measure 0.62 mm (per side), so there should be plenty of room for th…
-
Hi!
I stumbled upon the first iteration of your midi looper project and i have to say it's quite amazing, great job!
I saw this new version that seems to be a direct improvement of the original …