-
Hey everybody, I'm pretty new to this stuff. I'm connecting a RadioMaster Pocket to a Pixhawk 2.4.8 clone through an RP3 RadioMaster receiver. The devices are all charged, and the radio is bound to th…
-
### Describe the bug
When running PX4 rover on the pixhawk 6X certain rover parameters do not exist such as gnd_cruise which sets the speed of the rover. The rover also does not move when placed int…
-
### Describe the bug
I discovered a crash dump on one of my Pixhawk 6X units running the stable 1.14 version of the firmware. Currently, I have no idea what caused it or how to reproduce the issue.
…
-
### Describe the bug
I have two motors with a white wire and a blue wire on them. The white line controls the direction of motor rotation, and I connect them to AUX5 and AUX6 of Pixhawk respectively.…
-
What hardware requirements is there if i assemble drone.Please suggest any other flight controller other than pixhawk.
ghost updated
6 years ago
-
## Expected Behavior
Having QGroundControl opened, and having accepted location services and incoming connections, I connect through USB the **Holybro Pixhawk 6X (rev8)** or **6X-RT NXP (Developer Ed…
-
### Describe the bug
Using a Non PX4 CAN Node GPS, such as the Holybro DroneCAN F9P (Uses AP Periph). These Parameters that are required for CAN GPS Heading are not available in the **Component ###…
-
### Describe the bug
I am running a connection from a Pixhawk 4 running firmware 1.14.0. It is connected via a serial connection to a raspberry pi running Jammy and ROS 2 humble. This runs eProsima…
-
## Expected Behavior
Same Pixhawk with the same setting and same joystick input will have SAME PWM output to thruster.
## Current Behavior
Same Pixhawk with the same setting will have different…
-
Hi again!
I noticed recently when testing mavp2p with a pixhawk flight controller (with px4 firmware) that mavp2p does not support serial hardware flow control. Some PX4/pixhawk versions uses flow…