-
Hey Mike,
This is an idea a couple of us had on the server. We'd like to be able to make any sort of WE selection, then define a SchemSet or a mix of SchemSets and then have the SchemBrush populate…
-
The sky and the clouds are appearing dark to me as you can see in the pictures below. I have applied some post processing parameters but even when I turn them off the sky and clouds are darker than th…
-
There exist magnetic structure factor model describing the magnetic misalignment in a ferromagnetic bulk material arising from particle with magnetocristalline anisotropy. Moreover there exist another…
-
As a creator I want to be able to create a sky based on atmospheric scattering parameters and a single light source (sun). It should be usable as background and environment light source.
Reference:…
guusw updated
2 years ago
-
While i try to run propram, i faced follwing error, any suggestions ?
```
xsize = 10; % width of the region [mm]
ysize = 10; % height of the region [mm]
dh = 1; % discretisation size …
-
I am working on a project that required to extract the noise figure of the whole phased array system including the effect of mismatch connections. The system includes a bunch of active and passive mul…
ghost updated
2 years ago
-
When implementing raytraced subsurface scattering, the look of the material can vary significantly based on how the entry/exit bounce at the layer interface is handled.
The draft spec currently doe…
-
So far, the values set macros/tuning_parameters.mac are used. If the command `WCSim/tuning/abwff xxx` is also used in the 'main' config file then WCSim outputs 'Set the Rayleigh scattering parameter'…
-
The idea here is to parameterize the extinction function in terms of, e.g.
- air mass (Rayleigh scattering & O2 absorption)
- water vapor
- ozone
- aerosols
- clouds
This could probably be as simple …
-
In CHECK_NORM4 routine in file rad_scat4.f90 there is a check for the normalization of the scattering function. This fails for the passive calculations when using SSRGA and too large size parameters. …