-
I recently purchased a queen bee pro with the
xpro v5 controller. I have installed the latest firmware, cncjs software and I'm at the point where I would configure my axis'.
I've opened The seria…
-
Hello all,
I am running Bart Drings 4_Axis_ Daisy_SPI CNC controller https://www.tindie.com/products/33366583/4-axis-trinamic-cnc-controller-for-grbl_esp32/
with BigTreeTech TMC 5160 V1.2 Drivers
…
-
Hey,
I am trying to find the right settings for a Pololu Stepper Motor NEMA 11 Bipolar 200 Steps Rev 28×45mm 4.5V 0.67 A Phase for chopper configuration but even though I calculated the parameters …
-
Hello,
I am trying to make the TMC5160 vom BTT to work.
I am having the v1.2 and 1.3v of these stepper drivers.
Both do not have any solder pads or jumpers to change their used mode (as far as I …
-
Hi @teemuatlut,
thanks for updating the TRAMS board and all the work you do with the TMC2130/2208.
Wouldn't it be possible to use the TMC2130Stepper code also for the TMC5130 stepper drivers? As f…
-
Hey,
I wanted to experiment a little bit using the pico and tmc2209 drivers, in combination with homing/bed scanning. Setting "#define TRINAMIC_ENABLE 2209" throws me an error in pico_cnc_map.h, bu…
-
Hi, first of all sorry, i usually code in python, this is a little new to me.
I have the issue that i want to drive a stepper with a rather high speed (200RPM) and change the speed acording to an Ana…
-
Hey,
when I do rotate left, like `motor.rotate_left(num)` where `num` is in [0,2048] the motor rotates left. If I put in values above that it starts turning right. There seems to be a bug with the …
-
Hi Terjeio, I'm trying to use GrblHal on a SKR3-EZ board with 5160 drivers (4 axis). I had some problems with USB communication, but @Dresco helped me and solved it. Now I'm having problems with Trin…
-
Any chance this library could be used with TMC 2100 in the future?
I like TMC 2100 as they are more silent drivers.
Pedro