-
The instructions for the wiring harness are very minimal.
## High Beam
There are three wires that go to the high beam switch, and some that go to what they call the high beam terminal. We nee…
-
Hello, we're having a fairly consistent (meaning at least once every meeting) where we end up not being able to command our TalonFX motors. It's not so consistent that we can reproduce it reliably (a…
-
I am a newbie at this. I recently purchased a chinese laser machine and it came with a ben box controller. It has been nothing but problems. First the software has been very hard to load and even h…
-
Hello,
randomly I get the following error message. I use knutwurst custom firmware 1.5.3
I use a Anycubic MEGA X printer.
What could be the reason?
**Heating failed, system stopped! Heater_ID:…
anno0 updated
3 months ago
-
New pressure sensor communication PCB #113 & #114 and wiring harness #67 needs to be checked for clearances in full assembly model.
- [x] import new pressure sensor assembly A-TET-001017 to Alpha p…
-
Google for custom subwoofer sl500/r230 ideas.
-
Current rusEFI has no jumper provisions in this area - note it's GND SIG SIG GNS
![image](https://user-images.githubusercontent.com/48498823/146563711-67e1f871-51b8-48dd-92f3-37ddbf49e825.png)
A…
-
Motor control tests fine with 6V battery, but when switching to 12V battery there is no output voltage from either controller
-
To make the franken-mower we need to add:
- Cut down the drills and mount them to the mower rear wheels. Probably with some sort of shaft and 90 degree gear to keep the drills out of the dirt.
- …
-
We purchased the factory LCD for the soda machine to see if we can change the can/bottle 'type' on the broken soda machine column. Karl believes that it may be configured for bottles, and that this ma…