-
## Description
If one finishes a grand prix in story mode and afterwards the amount of points is higher than 190, the first kart (Amanda) gets unlocked, but it is not shown in the trophy screen.
N…
-
Hello everyone,
I have two Yaskawa robots, MotoMini and GP4, in a robot module, each controlled by a YRC1000micro controller, and I would like to control them simultaneously via ROS2 Humble. The robo…
TE-2 updated
4 months ago
-
Power off the phone before connecting.
For brom mode, press and hold vol up, vol dwn, or all hw buttons and connect usb.
For preloader mode, don't press any hw button and connect usb.
If it is alre…
-
I'm trying to combine kmk firmware with oled screen
the oled screen runs correctly but I get this error:
`Auto-reload is on. Simply save files over USB to run them or enter REPL to disable.
code.p…
-
command: mtk da seccfg unlock --noreconnect
I suspect that the da in mtkclient cannot be used. Its official tool seems to use specialized da.
printgpt, read and write partition is available. can I u…
-
Version from master branch
```python mtk_gui --preloader mtkclient\Loader\Preloader\preloader_es2.bin```
```
Power off the phone before connecting.
For brom mode, press and hold vol up, vol dwn…
-
**Describe the bug**
A clear and concise description of what the bug is.
**To Reproduce**
Steps to reproduce the behavior:
1. create a report where the context size is too big for GP4
2. *bug*
…
-
### CircuitPython version
```python
On the transmitter microcontroller I use version 8.2.4. On the receiver microcontroller I use version 8.2.6.
```
### Code/REPL
```python
################# trans…
-
Hi,
I've been able to get the GPT from the device and dump all the partitions.
However, on next reboot I'm unable to connect. It detects the SoC but fails with `DA_IMAGE_SIG_VERIFY_FAIL`.
An…
-
I have two builds going and can't identify any soldering defects but on both boards the X, V, U and O keys (in standard QWERTY layout) don't work. I'm guessing the mirrored problem keys are due to the…