-
installed the 6.0 RC3 on my nano Goblin plank today.
Was absolutely blown away by the horizon drift elimination, what a treat thanks to all that contributed.
But there was one strange moment when …
-
## Bug report
**Issue details**
**Issue 1**
Runcam camera control ignores RC reversals.
Exact steps to reproduce:
1. Set elevator reversal **in transmitter** such that moving the pitch s…
-
Hi
Thanks for developing this tracker & the support you provide. I read your RC group thread and still a little bit confused most probably due to my lack on knowledge in this area!
If I'm to…
-
## Current Behavior
No available target for AocodaRC F7MINI
## Desired Behavior
please add a new target for the board
## Suggested Solution
## Who does this impact? Who is this for?
…
-
When Spektrum brought out 'Forward Programming' it was a convienient way of setting up a Rx from your Tx.
Unfortunatley, with their latest Rx (the AR637T), it is now the ONLY way to configure the Rx.…
-
## Current Behavior
With RTH set to AT LEAST LINEAR DESCENT and arriving altitude is much higher than Home Altitude, it causes a rapid climb for some time.
## Steps to Reproduce
1. Activate RTH …
-
Hi all!
I’m still waiting for upgrade module kit to try ethos, but have few ideas about ethos.
Biggest issue with opentx is bad wizzard...
Before I had multiplex radio, that had few very interestin…
-
Using RC OPTION for disabling airspeed use....started flying in VTOL, with AIRSPEED_USE disabled by RC switch..my first attempt to FW transition failed, and even after I switched the switch off, and c…
-
Today i was testing some antenna setup with my test plane and did about 10 flights. Now and then I test RTH in order to fine
tune the planes behavior and to make sure it will work. so today at a numb…
-
Controller: Matek F411 Wing
ESC: ZTW 30A, but problem also exists within other ESC's
Motor: A2212 6T
Yesterday, I was flying my pretty big plane at the model club and after full throttle, the mot…