-
We'll probably drop the baremetal support completely unless somebody submits an easy fix soon. The problem is that the file `chip.h` is missing, possibly something else.
-
由于众多 BSP 中缺少最新 DMA 方式的串口设备驱动的实现,整个设备驱动的流程并不明确,自己摸索中实现了一套 DMA 方式的串口驱动,但涉及到 RTT 源码中一些细节存在冲突,便产生如下疑问:
- 1、`dma_transmit` 使用疑问?
``` C
struct rt_uart_ops
{
rt_err_t (*configure)(struct rt_serial_devic…
-
- The new version does not save the protocol of UBLOX GPS.
Before the upgrade everything worked!
-
I'm using the Naze32 Rev5 board with Cleanflight firmware "1.9.0 NAZE 2015-6-2 0:41 (stable)", and I've built a basic current monitor that consists of a 2W 0.001 Ohm resistor (=44.7A max) between a 3S…
-
I tried GY-63 baro board with CC3D without any success, both cleanflight 1.8.1, 1.9.0.
Baro works with arduino.
Also, unsoldering 22K pull up resistors makes no difference.
Logic analyzer i2c sequence…
-
As a result of awesome investigation by @theArchLadder in #218 , force `gyro_sync_denom=8` when `gyro_lpf=256HZ`. This is because gyro enters 8kHz mode and higher denominator is required to keep loopt…
-
Hello everyone
Just a repost from the **mbed** forum. Hopefully more **F103RB** users read this post and can test and confirm whether it worked.
Here is my attempt at a **NUCLEO_F103RB-device.mk** f…
-
Hello,
i'm wondering if someone could give me hand and help me figure out what to change to have the WS2811 LED strip use a different timer and pin on a Naze32 (and maybe others).
The reason is …
-
I have followed your tutorial an got it to work with simple GPIO and loop-delays.
Then I tried using ISRs and it simply did not work.
Everything compiles without a glitch and loads into the targe…
-
Failed with RC10.
Need to push boot pin to reflash. Tried with erase all and still failed.
Did a little search to see where it brok, was previously running a older RC from a week or two ago. Al…