-
- [x] Read Cell Voltage
- [x] Read Current
- [x] Coulomb counting
- [x] Gain Control
- [ ] Fault algorithm -Andrew Thornborough
- [x] Bypass algorithm
- [ ] Charge Control -Andrew Thornborough
- [ ] …
-
This camera has Day, Night, LED, BW mode presets which you can change by long pressing the right button on the remote control board. I'm having an issue where camera control automatically changes to …
-
Hello Stuart,
(All in one version 490)
I would like to understand exactly how balancing works. Firstly, it is possible to set a global voltage, e.g. 4150mV. If this is exceeded, balancing is sta…
-
I am using custom board based on `nucleo_f767zi`. I have an external RTC clock and I'm trying to use it for the RTC:
overlay:
```
&clk_lse {
status = "okay";
};
&rtc {
status = "oka…
-
I tried 21.3.2. and 21.10.1 - i install only display drivers w/o AMD software.
Settings for clocks and voltages work, but there is no way (fan_control and fan_control_navi) to crank the speeds up. …
-
hello,
both of my q1 pro printers led light strips flicker badly while printing, they never did so for the first 6 months of owning them. after one of the previous updates is when they started fl…
-
Hi! This may be me because I'm fairly new to IOT development, but I wanted to use this library on Platform.io instead of the arduino IDE, but it's not clear to me how to add it unofficial boards (if a…
-
Are there any plans to add support for changing charger_source_priority value as is the case with output_source_priority_solar?
-
MWE causes error below.
```Julia
using ModelingToolkit
const MTK = ModelingToolkit
params = MTK.@parameters begin
t
# AC side quantities
ωb # Base Frequency
…
-
Hi all,
My bltouch suddenly stopped working without any wiring or firmware change. No fix is working found all over the internet.
I just measured the voltage when sending m280 P0 S10. And the vol…