-
Using Adafruit Nordic nrf52 / nrf52832 Wire
What is causing i2c to hang? Absence of NACK?
**********************
Remote debugging using localhost:2331
0x00026830 in TwoWire::endTransmission (st…
-
hi
i have problem to install firmware using Arduino on ESP32 NodeMcu.
When upload i obtain error message:
In file included from C:\Users\scdstf\Documents\Arduino\libraries\madflight\src/madflight…
-
Hey Kris, i wanted to get readings from two MPUs but since there is only one mag address the solutions i could find was using a multiplexer. Is there any other way? Should i consider using SPI interfa…
-
### Prerequisite
- [X] I have searched [Issues](https://github.com/open-mmlab/mmdetection3d/issues) and [Discussions](https://github.com/open-mmlab/mmdetection3d/discussions) but cannot get the expec…
-
### Describe the problem
I have the following setup: https://github.com/arduino/arduino-ide/pull/1132#pullrequestreview-1031068976
When I start the application I see the following errors logged:…
-
Hello.
I accidentally download my own firmware to the board. Therefore, the firmware update instruction provided by SparkFun doesn't work. Could you please support me to recover my board? I need the…
Vanbk updated
6 months ago
-
Hi.
I was wondering if you had made any comparison on these 3 chips, especially in terms of the magnetometer, which has been a big problem for me on the Invensense in terms of error.
-
Hello Kris,
I have implemented your code for 9250 with STM32F401 MCU.
The problem that I have is when sensor is flat and still, the calculated Q values are changing at a constant speed (big drifting…
-
### Prerequisite
- [X] I have searched [Issues](https://github.com/open-mmlab/mmdetection3d/issues) and [Discussions](https://github.com/open-mmlab/mmdetection3d/discussions) but cannot get the expec…
-
The firmware 01.01.01 crashes when the logging rate is set faster than 100ms logging interval. The error is:
Guru Meditation Error: Core 1 panic'ed (LoadProhibited). Exception was unhandle
d. …