-
re-design
add wind gust value
-
HW: pixhawk (fmu-v2) + quadcopter x6
FW: px4 stable in EKF2 mode
I've found that on full thrust there are actuators oscillations with roll ~45 degree.
To ensure that is not related to frame vibra…
-
-
Hi,
I'm just discovering weewx and want to say hi. I'm working on a project to set up a weather monitoring solution for airports. As you can imagine, weewx provides a ton of functionality. Since I …
-
Can I check with you, this dji_sdk/flight_control_setpoint_generic works like typical RC just that control by serial, right? Is it in stable mode? I tried to control this using Logitech joystick. but …
-
### **Bug Report**
**LOG:** https://logs.px4.io/plot_app?log=962b0f4e-3553-4ec2-b398-40258c9286e5
**Explanation:**
The PX4Flow is only valid at 35cm of the floor.
To reproduce, handheld the…
-
I am converting a spinning lidar information to distance sensor information, and sequentially sent it over to my FCU. But after setup the plugin and make sure my node is publishing data, I cant oberse…
-
Hello,
We made a mission without RC control only with the QGC. We used version 3.1.3. Everithing went ok except the land detector did not disarm after the mission was complete and the VTOL was land…
-
@jgoppert With latest master something with LPE must have changed massively. I've SF10A Lidar and PX4Flow attached. Sonar altitude seems not to be recognized at all, and even with LIDAR the estimated …
-
I think the newest update to the firmware have a bug in it where i cannot run the package, and it hangs my laptop everytime I want to run the command make posix_sitl_default gazebo. Does anyone else h…