-
I installed BLtouch on my homemade printer with Marlin 1.1.9 recently and it doesn't compensate the bed leveling. Before I installed BLtouch, the bed limit switch for Z axis seems to work perfectly wi…
-
Board|MCU|State|To-Do
-|-|-|-
8-Bit AVR boards, RAMPS, etc.|Arduino AVR|💚good|
Due, RAMPS FD (v2.A!), etc.|SAM3X8E|💚good|
Duet Wifi + X5|SAM3X8E|❓unknown|E3D Toolchanger on hand
Duet 2 Maestro|SA…
-
Hello, the mainly config like below:
```cpp
#define Z_DUAL_STEPPER_DRIVERS
#if ENABLED(Z_DUAL_STEPPER_DRIVERS)
#define Z_DUAL_ENDSTOPS
#if ENABLED(Z_DUAL_ENDSTOPS)
#define Z2_USE_ENDSTOP…
-
-
### I need help on my 3d Printer, the bed size is 400,400 but i only try to use 330 by 300 but when i do the bilinear auto bed leveling it would say probing failed at the 7th probe, i tried reduci…
-
I have sporadic freezes with Linux Mint 17 Cinnamon 64, only the mouse pointer can move. I can switch to another terminal. Programs keep running, music keeps playing (until the next song), just intera…
-
This is Marlin bugfix-2.0.x branch, commit 61225e68, running on an SKR v1.3.
### Description
For a while, I've been having problems with my hotend staying... well... hot. At the beginning of a …
-
You guys are always so helpful and have taught me so much already, but I keep discovering new issues with my firmware. After updating my firmware to the latest 2.0.4.3 bilinear autolevel fails at the …
-
1. do not insert sd card
2. slow lcd respond with 0.5 sec for each line refresh
3. insert sd card
4. it become normal operation
5. take out sd card again
6. slow lcd repsond again ...
Regards
…
-
```
Marlin/src/lcd/menu/menu_delta_calibrate.cpp: In function 'void _man_probe_pt(const float&, const float&)':
Marlin/src/lcd/menu/menu_delta_calibrate.cpp:42:76: error: 'DEFAULT_XYZ_STEPS_PER_UNIT…