-
I would like to set up my Bigtreetech SKR v1.3 with TMC2208 drivers to use Z1 and E1 steppers to control my two Z motors to take advantage of Z motor leveling in Marlin 2.0. Can you do this and does a…
-
I'm sorry for my bad title but I couldn't think of a better one.
I am using StepperOnline DM860T drivers connected to a GRBL controller.
Previously I used cheap TB6600 drivers which worked instant…
-
The readme file says this is EPICS motor drivers for the following Kohzu controllers: SC-200, SC-400, SC-800 stepper motor controllers.
Does this support the latest version of Kohzu controller ARIE…
-
Using very simple setup. Actually, limited it to just ESP32, trying various drivers and AS5600 sensor.
Motor running ok in velocity mode and angle open-loop.
Even though in the open loop it gets …
-
I've been using a scanner with my setup for quite some time now, but I noticed that compared to lots of other videos featuring a scanner or large stepper motor of some kind, mine sounds awful in compa…
-
I have a Robin Mini on a Kingroon KP3. The extruder stopped working after a I had a filament jam. The extruder motor turns on other driver ports ( x /y ) but the E port seems to no longer work. I can'…
-
Hello,
I've found no way to get this board working with dual Z driver and dual Z endstop.
The second Z driver (Z2) was recognized, but the endstop resource never be used.
My actual configuration …
-
```
What steps will reproduce the problem?
1. use the right motor test slider
What is the expected output? What do you see instead?
for the left slider to rumble the big motor and the right slider to…
-
```
What steps will reproduce the problem?
1. use the right motor test slider
What is the expected output? What do you see instead?
for the left slider to rumble the big motor and the right slider to…
-
Have the following specs been documented and requirements met?
- Motor
- model, speed, minimum and maximum power requirements (voltage and amps)
- Motor driver
- model, minimum and maximum p…