-
Hardware
Radio Taranis X9D+, XSR Receiver or R9Slim+, Betaflight F4 PRO V3 or F405Wing. PC with Win 10 PRO
Firmware
TX 2.3.7, RX XSR 2.1.0 or 190201 R9Slim+ , Ardupilot 4.0.5
Companion 2.3.7
I …
-
I downloaded your release candidate from the built in Bluetooth thread. I could not make a connection until I powered up a bound FC. Once I did, the connection was quick and I was able to verify con…
-
PR #61 adds support for the MSP protocol in ELRS. We need to define some requirements around how it will be used within the codebase.
Some considerations are:
* Which UART will MSP use to send/r…
-
## Current Behavior
I updated my drone from inav 2.0.1 to 2.2.1 and FPORT stops working. With the old version it works. I tried for 2 hours, soldered it to different pins, cli commands (inverted, hal…
-
Friends, help please.
I connected my HC-06 to my R9M via smart port, but the bluetoth module lights do not turn on indicating it is working.
I tested the HC-06, not a fault of it.
It seems to me th…
-
Found this git source link from here:
https://www.rcgroups.com/forums/showthread.php?3089648-Mavlink-To-FrSky-Passthrough-Converter/page5
I am using the Frsky R9/R9M Long Range UHF combo and I'd l…
-
Ciao Alessadro,
I was trying to setup your widget; my setup:
_Jumper T16 radio
R9M module
R9MM receiver
**FPort**;
Betaflight_
The telemetry works, I have all the data on the radio:
![photo…
-
## Current Behavior
Currently INAV is exclusive to things in the air.
## Desired Behavior
Ability to utilize INAV Configuration App to easily set up flight controller for stability control, GPS, …
-
Hi I have been searching for an antenna tracker I could use with Inav and the frsky r9m system. I have gps telemetry coming into my radio from my FC. Can I hook up this antenna tracker to the smart po…
-
The calibration does not show the 30 seconds any more.
Calibration does not work.
After it stopped the values are still 0 after save and reboot.
The compass seem to work. Just the graph is not show…