-
Hey Fish, (@Fish-Git )
I’m inviting you to weigh in on a discussion about a problem in the MVS assist code in assist.c. First off, I’m not asking you fix anything or change anything. I already k…
wably updated
3 years ago
-
### Description
After flashing the new CF6 Pre 3 and reseted my printer to factory settings I noticed that I can't change the E-Step value to my known good value directly on the printer without the…
-
Hi, i have a Longer LK4 Pro which has the same LCD of CR6, hence i tried to use your GUI on my printer. I had some trouble to compile your code for the original atmega2560 based board, and finally it …
mrv96 updated
3 years ago
-
Hi, since i upgraded to the community firmware, setting the temperature on the extruder is a bit weird.
I can pre heat the extruder and bed, and then I load a print job from SD, extruder temp will be…
-
### Bug Description
Firmware does not install, nothing happens.
### My Configurations
Creality CR6 SE
Currently installed firmware 1.0.3.6
### Steps to Reproduce
I follow the instructi…
-
### Description
I encountered a bug while printing earlier in which the following the automatic start-of-print homing I noticed that the temperature of the nozzle had been reset from 230C to 12…
-
Hello!
Thanks for your work!
I've read on reddit you fixed it, but it I see still it this way.. anything I can try?
Thanks for your work!
-
Hi,
I printed many stuff with Cura Version 4.8.0 and my Creality CR 6-SE and it worked well. But since one day I struggle with the retraction. I use a GCode simulator to look if there is any retract …
-
### Description
When filament runs out, the printer does an audible alert and unloads filament. But between this, it shows the filament runout screen.
### Steps to Reproduce
*If this is a Bu…
-
### Bug Description
After flashing extui-btt-skr-stock-tft branch to a BTT SKR CR6, the serial port is non functional and showing as an unknown USB device in Windows. After some looking about it s…