-
I have tried multiple times to run a bed level through Bed Visulaizer and always get this error. It worked at one point, then started doing this. If I run a Bed Level from LCD it works without any i…
-
I'm running UGS platform (I tried stable and nightly, but no difference there) on a Raspberry Pi 4 with a Sainsmart 3018 pro. When I run a bigger gcode file I have the problem that the Visualizer and …
-
The 3 square pockets in this example are 8mm wide, with a 3mm bit.
They should be 3 passes per level, the algo just makes 2, leaving a stud in the middle
Same result with and without depth first
S…
rqhub updated
4 years ago
-
When the "Update mesh now" button is clicked, it clears all custom actions under the **system** section of config.yaml after updating the mesh.
Steps to reproduce:
1. Click "Update mesh now".
2. …
ghost updated
4 years ago
-
I have a Prusa MKS3 and I'm getting stuck with the "Please wait, retrieving current mesh." message. I read the thread at https://github.com/jneilliii/OctoPrint-BedLevelVisualizer/issues/4, but it's w…
-
Hi!
What i'm seeing; when having a non-zero lift-z-on-retract and a height difference between the first and the later layers, generated gcode will put the second layer at the first layer's height (cr…
-
There is a dependency to the gcode visualizer and the Dashboard will not load if it has been disabled by the user. Either try to recover from the error by disabling the bindings or display an error …
-
### Bug Description
BLTouch leveling isn't working on 2.0.7.2 (also confirmed on bugfix-2.0.x, see comment below), ~~and it shifts the Z to 5 at the end of the leveling (from the normal 10 - z-offs…
-
**Describe the bug**
**Expected behavior**
**Debug Log**
**Screenshots**
**Firmware and Version**
-
Do you think it could be possible to visualize an extrusion?
Here an idea with magnifying x10
![image](https://user-images.githubusercontent.com/25530011/82731965-8122d980-9d0a-11ea-9909-bdf75174244…