-
### Version
git version_2.1.0-513-g3b084c50c
### Operating system type + version
tested in Manjaro Linux (g++ 9.2) and in Windows 10 (MSVC 2019)
### Behavior
reproducible assert fail or segfa…
-
Hi,
I'm a fairly experienced Prusa user (and embedded firmware dev). I was just using the modifier feature in recent PrusaSlicers and noticed a bug:
If you use a modifier (in my case three cyli…
-
This is a future feature request to include the gyroid improvement shown here:
(note: Not currently stable, I'm just marking it for the record so we can hopefully suck it in in the future and make on…
-
I made an implementation of ```BRepOffsetAPI_MakeFilling``` into CadQuery in order to produce a plate surface with a thickness, enclosed by edge points, and going through interpolation points. To this…
-
### Bug Description
After replacing my mp select mini board with an e3 mini skr board sometimes during a print the board completely freeze with heater on and fan on. Tried both via SD and octoprint…
-
Every 30 seconds we fully refresh the LCD. When running some complex GCODE (a good example would be a large area with >30% gyroid infill), the full lcd refresh is an operation that may delay enough to…
-
There's already some code in Slic3r to generate Arc commands (G2, G3). Either it was never finished in the first place or it got broken over time.
I was able to reenable it by adapting it to some m…
-
### Description
Since the last update 2.0, the Linear Advance with a K value greater than 0 makes
line stair for the diagonal that make the printer vibrate unnaturally.
Borad : SKR 1.3 (CPU…
-
It would be useful in use with octoprint when moving STL and slicing with Cura engine to move and rotate an object before slice.
-
**Application version**
4.7.0, 4.7.1, possibly earlier.
**Platform**
Windows 10 x64 1909
2x GTX 1080 Ti in SLI
CPU: Intel i7 6800K
RAM 32GB DDR4 @3000 MHz
**Printer**
Creality CR 10 MA…