-
The .6 beta OVA can not be imported into QTS 4.3 running VS3. TS453B x86 based QNAP.
Error is not very useful.
**Import VM fail**
[Import VM] Import VM fail config format error: Unknown ovf for…
-
Just came back to a print that failed with `Err: EXTR. FAN ERROR` [with the bed still hot.](https://imgur.com/a/LVISL1W)
In this particular case it was due to filament getting stuck inside the extr…
-
Another 4" hole needs to be drilled in the temporary wall for Room 9, 16.5" from the permanent wall, 6" down from the ceiling, to match the one that already exists over the door to Room 9.
Use plas…
-
Looks like you are slated to do a part cooling shroud.
Might I suggest this design as an option? https://www.thingiverse.com/thing:3063554
it will keep the fan vertical thus not having an issue…
-
Description:
An beeping (high frequency, but quiter than the regular start signal) if the code is reaching the second layer. video (link to youtube) follows tomorrow.
ANY I3 Mega
MODs:
Only re…
-
Hello,
i replaced the cooling fans with new ones from noctua and flashed your firmware for 12V pwm output. The Hotend cooler (always 100%) runs fine, but the part cooling fan start to run about 70%+.…
-
EDIT: This thread has been very helpful. There is definitely a hardware problem here and Creality has been SUPER slow about and "round about" in regards to providing help. Long story short: When m…
-
**Describe the bug**
I enabled PWM output on different pins (3, 18,12) for an inputted frequency of 25000 Hz (25 KHz).
When I measure the output I can see the PWM signal but only at 5800 Hz (5.8KHz)…
-
**Describe the bug**
This may not be an issue with the firmware but my hope is the experts around here might be able to lend me a hand. I installed the firmware on my upgraded i3 Mega which has a Tit…
-
Ok so what I am looking for is how to change the Mk3 firmware to accomadate a 12v power supply and the mk42 heatbed but make use of the original pinda 2 probe and the prusa filament sensor.
I have a…