-
Hi!
What are the considerations if I would like to increase the constant charging current from 200 mA to a higher value? Will charging the battery with up to 1A work (as the enum __xpowers_axp2101_…
-
Hi,
I just installed the latest version from the main branch successfully from with pio (console). Now the start screens shows up, display shows after some seconds LoRa initiated and then switches t…
-
The schematic for the T-Beam_V1.2 has "T-Beam_V1.1" written on the sheet. Does this version also apply to the "1.2"? I have a question about whether the +5V pin can also charge the batteries, but look…
-
Hi,
The docs mention support for the "TTGO T-Beam V1 (433MHz SX1278)". Is the 1.1 version of the board also supported? Those seem to be the only ones i can buy on AliExpress. [Link](https://nl.alie…
-
I am having issues even to compile the example code in Arduino as when I execute the code, it goes into a infinite watchdog reset loop.
I followed the setup for ESP32 Dev Module. I cant figure out w…
-
Unfortunately, I can't get the application to work properly on my brand new T-Beam 1.2 (LILYGO 868/915 Mhz). The original software (meshtastic) worked without any problems, I think the hardware is OK.…
-
Hello,
I have tried this function on the M5Core2:
M5.Power.setLed(0);
M5.Power.setLed(1);
M5.Power.setLed(255);
I tried that too:
auto cfg = M5.config();
cfg.led_brightness = 1;
M5.begin(c…
-
plase add support for board ttgo-t-beam-AXP2101-v1_2
-
### Category
Other
### Hardware
T-Beam
### Firmware Version
2.3.8
### Description
After freshly flashed and reset a T-beam v1.1 board (the 433/470 MHz variant with SX1268 chip), directly settin…
-
Hello,
I'm trying to find out what voltage to apply to the CoreS3 LCD backlight?
Could you tell me the voltage for DLDO1 (LCD BL)?
I couldn't find here:
https://github.com/m5stack/M5Unified/bl…
lboue updated
2 months ago