-
### Is your feature request related to a problem?
Getting that first printed line to stick to the bed properly can be very difficult depending on filament type/condition, nozzle purging, and many oth…
-
### Version
Any version
### Behavior
Parts with sharp corners have a high chance to warp if they are printed in certain materials(ABS,Nylon,etc). An option that reduces the amount of material in …
-
### Version
2.2.53
### Operating system type + version
Windows 10
### 3D printer brand / version + firmware version (if known)
Anycubic i3 Mega (Marlin 1.9)
Custom HEVO (DuetWifi on Reprap 2…
-
Hi everybody,
I have an issue with upgrading my ZProbe : I bought an inductive LJ12A3-4-Z/BX sensor that I chequed apart. It gives 11,5v on the signal wire when I connect to my power supply and ap…
-
@thinkyhead @Roxy-3D
Hi , UBL strange behavior outside of bedsize , up infinitly and more strange things, i have a purge bucket outside of the bed ' impossible to probe this void zone '
How to…
ghost updated
3 years ago
-
### Version
2.2.1
### Operating system type + version
Any
### 3D printer brand / version + firmware version (if known)
Any
### Behavior
Not PrusaSlicer's fault, but I have a small bulge (…
-
### Version
PrusaSlicer-2.2.0+linux-x64-202003211856.AppImage
### Operating system type + version
Ubuntu 18.04 x86_64
### 3D printer brand / version + firmware version (if known)
custom, most…
-
Stock Trigorilla board. Newest bugfix 2.0 with config from examples folder with changes below:
```
#define ANYCUBIC_KOSSEL_PLUS
// Anycubic Probe version 1 or 2 see README.md; 0 for no probe
#…
-
Different filaments don't just need different print temperatures, they need different first-layer temperatures as well. Just setting a global first-layer temperature via the chosen quality profile is…
-
In config.g you have
> M671 X-20.6:200:420.6 Y14.3:333.3:14.3 S2 ; Locations left, center, right
defining the Z axis locations for the auto leveling process
In bed.g you have
> G30 P…
ghost updated
4 years ago