-
Im trying to set up a slae.shCC2652R stick with open thread firmware. I chosen the correct device and the correct baudrate. The error still happening.
When I start the web ui the page only says 502…
-
The readme states that the CTs must not exceed 33mA peak output, yet the models suggested go up to 100mA. What is the correct maximum mA output value? I have 30 and 40A 240V (USA) breakers I want to m…
-
## Do not report new issues related to this message, instead please comment on this issue with the logs that you see and the config for that component.
### The problem
```
[00:00:00][W][compone…
-
### What happened?
Hello all,
I am having some problems with the Zigbee2MQTT and my routers (CircuitSetup's CC2652P2 and Sonoff 3.0 Dongle Plus).
I flashed the routers with the "CC1352P2_CC2652P_l…
-
# Problem Report
After panelizing a board, and running a fiducial check, the board location is not updated. This goes for any board in the panel. It seems as though the location is saved somewhere, …
-
On the TCD:
As long as I can remember, this has been the case in Night Mode. The ” : “between the hour and min display is “OFF” when in Night Mode. During normal operation these flash once per seco…
-
Hi there with version 2.8 my temp/humidity sensor and speedo display are no longer enabled.
The check boxes to enable the sensor and speedo display that were in 2.6 are gone (although the options t…
-
Hello :)
## What happened
After a day or two running perfectly fine, routers kind of disconnect from the network; trying to execute any command results in timeout.
It happens for all routers I ha…
-
Hello! I have to assume that the issue that I have is some form of local configuration or incorrect setup but I've wracked my brain for a while and haven't been able to figure it out.
For context, …
-
I am using the example ESPhome config and noticed that one CT channel reacted very differently to my large (supposedly) balanced 240V EVSE load. Fhase C reacts, but with much lower absolute reading.
…