-
@ataffanel Can you tell me if there is fix bootloader for GPIO Orange Pi?
I do not know if Raspberry and Orange GPIO ports match, but I doubt it very much.
-
**Descriptions**: We have a custom topic to log two parameters: pm.state and pm.vbat. The custom topic is published at a desired rate (10Hz) when running multiple crazyflies. However, if we add non-cr…
-
python2 ../usbtools/launchBootloader.py
Launch bootloader Traceback (most recent call last):
File "../usbtools/launchBootloader.py", line 95, in
sys.exit(launchBootloader(True))
File "../…
-
## The problem
Crazyflie 2.1 does not work. All LEDs except one are lit without heartbeat (there are 2 red LEDs, 2 green LEDs and 2 blue LEDs. If I'm not mistaken, the blue LED corresponding to the s…
-
Hi, I'm not sure if crazyradio PA is under FCC compliant, so I would like to use another product with firmware instead of crazyradio PA or 2.0.
What configurations are considered compatible with craz…
-
Hi
I wanted to implement the `quadx_hover_env` of Pyflyt on real hardware using CrazyFlyt.
I was looking at this file:
https://github.com/jjshoots/CrazyFlyt/blob/master/examples/sim_n_fly_sin…
-
I'm unable to get a Crazyradio to be recognized by a raspberry Pi as anything other than a "Nordic Semiconductor ASA". My output from `lsusb` is shown below:
```
ubuntu@ubuntu:~$ lsusb
Bus 002 Devi…
-
We have a vicon system with crazyflie 2.1 and crazyradio pa. We are using kalman and mellinger. But when we attempt to hover with one Crazyflie with a unique marker configuration it crashes almost im…
-
Hello,
I am attempting to use a MPC controller computed on my laptop running Ubuntu 20.04 to control a single CrazyFlie 2.0. My controller takes the state of the cf from CrazySwarm using a Vicon t…
-
Hi,
When I used crazyradio2, I received the error: LIBUSB_ERROR_TIMEOUT.
Can you advise on this error?