-
Hi,
Scratching my head since a few hours ... Has anybody tried to do some analogRead() with the L151CCU6 variant (LoRa Node L151) ? Getting zero, zero and always zero ;-) And I confirm I have 3.3 v…
-
I'm currently have V1.1 (latest one in board manager)on my arduino IDE, it only has AS923 in the region section, I saw you have AS1, AS2 support on the board.txt, how do I update mine to have AS2 supp…
-
in the library.properties file the option architectures is inconsistant sometimesit is ASR650x-Arduino sometime CubeCell
this should be fixed for the next release
-
I have two Cubecell 1/2AA boards. They will transmit LoRaWan to TTN without issue when connected to the USB port (with or without the battery installed). If I disconnect the node from USB power (henc…
-
Hi, I want to integrate the cube cell into arduino. Unfortunately the link is dead. I need the json link for arduino boardmanager.
Greetings Tom!
-
When I set up RGB OFF it stops with "-> Enter state Measure".
My setup is Cube Cell, HX711, DHT22, no One-wire
I have tried to set "#define THERMOMETER_COUNT 5" to "0", but then the compilation fai…
-
Hey,
I bought a CubeCell recently. The (battery/solar powered) device will read data from an external (wind) sensor and send received data via LoRaWan (TTN). LoRa-uplink works fine (except some frame…
-
Just did a few Measurements with the actual Firmware:
Current was measured in between Battery and the Cubecell Board without USB Power.
1. LCD on, GPS: on: 50-63mA
2. LCD on, GPS off: 17.9mA
3.…
dj1an updated
2 years ago
-
[platform.txt](https://github.com/HelTecAutomation/ASR650x-Arduino/blob/V1.0.0/platform.txt) contains a _version_ field. It's current value is set to 0.0.1.
> name=CubeCell
> version=0.0.1
The …
-
Hello,
Trying to read SCD41 using Sensirion I2C SCD4x library, but compilations give below error:
.
.
.
C:\Users\DELL\Documents\Arduino\libraries\Sensirion_I2C_SCD4x\src/SensirionI2CScd4x.h:399…