-
### Version
2.3.3 or 2.4.0 A3
### Behavior
problem is during a multipart print.
**First issue**, after finishing the first part, before executing the "between objects g-code", the gcode bring…
ghost updated
3 years ago
-
# 🐞 bug report
### Affected Version(s)
The issue is caused by version 3.14.0
### To Reproduce
Steps to reproduce the behavior:
1. Go to CNC carving workspace
2. Select 4-axis
3. Set model s…
-
### Version
SuperSlicer_2.4.58.5
### Operating system type + version
Win11
### Behavior
* _Describe the problem_
SS not using all the CPU Power n Gcode generation
* _Expected Results_
When…
-
Currently CuraEngine does not output M73 commands to the generated GCODE, which is helpful for updating the progress bar.
I can see two ways to implement this feature. Either add a flag which enabl…
-
After performing multiple gcode generations with multiple files eventually a new document stops showing in the workspace.
Restarting fixes the issue. Sometimes but not always "reset"ing the workspace…
-
I have been trying to write a klipper config for the Sigma R19 and got this working partially.
Some things I need to know are sensor types etc. so that I can run a calibration and get this up and r…
-
Hello!
PCB milling requires using height map of pcb, because copper layer has the same thickness as height irregularities. It would be useful to read pre-measured height map for gcode generation
…
-
### Description of the bug
During the printing process of a model, Klipper automatically exited twice at the same position, displaying an error indicating it was out of the printing range with some s…
-
### Feature Name
Research about Stability.ai
### Feature Description
This a research about Stability.ai, learning more about its supported models, how it is used and many more
### Motivati…
-
### Wiki Search Terms
"Low Memory"
"SD Card"
"LocalFS"
### Controller Board
MSK TinyBee
### Machine Description
Using MSK TinyBee to control four motors. UART is used to connect with an externa…