-
Hello, i have connected arduino nano with taranis on XJT pins (SIG and GND) and arduino nano is connected with USB to APM Planner, and cannot verify is it working.
Also i have connected GND and TX …
-
I've been setting BEEPER -ON_USB via the CLI for many years but on the latest few versions of iNav, the beeper continues to beep while the FC is only plugged in the USB cable. This issue occurs on al…
-
## Current Behavior
artificial horizon drift
## Steps to Reproduce
fly, turn a bit, fly level, horizon is off.
## Expected behavior
horizon not lag or drift
## Suggested solution(s)
…
-
Hello,
i'm trying to acquire Galileo E5 signal for position fix.
GNSS-SDR runs without errors but i can't receive Galileo INAV messages. I'm using nuand bladeRF x40 equipped with u-blox antenna fee…
-
Hello,
can we add inav support to this 20x20 F405 little board?
it have BMi Gyro
the betaflight target is JHEF405PRO.hex
https://github.com/betaflight/unified-targets/blob/master/configs/default/…
-
I think that I have found an important error in Inav's configurators (not important the version)
When user try to change the frequency of this rate nothing in reality happen. Used scope I have foun…
-
System time gets logged in microseconds as an unsigned 32-bit integer[^1]. This gives a max uptime of just over 1 hour 11 minutes before it rolls over. `blackbox_decode` [handles this](https://github.…
-
## Feature request
**ESC may delay startup when using folding propeler or heavy propeller**
If the AUW is near the max supported by a airframe, delayed spinning will cause crash
**My proposal i…
-
Cant this be built into the Inav Configurator?
[Inav Issue. ](https://github.com/iNavFlight/inav/issues/7748#issue-1103530430)
Imagine to have a way like this for All external Hardware that needs …
-
I have tried the latest version on both iNav and Arduplane equipped airplanes.
Working great !
The iNav planes (multiple) are all using Sbus-Sport telemetry, the Arduplane (only one) is using F-…