-
Similar to #21 I am getting:
```console
[00:00:00.000] (7fdeacdbe7c0) INFO Getting the derivations from .#
[00:00:05.813] (7fdeacdbe7c0) INFO Found 809 derivations
[00:00:05.813] (7fdeacdbe7…
-
## Current Behavior
I use a **Matek F405 VTOL** and a **FIMI Manta tilt rotor VTOL**
The "Motor 1" is connected to the motor at the rear.
In **tricopter** mode, everything work fine.
In **flyi…
-
## Current Behavior
The optic flow & lidar sensor MTF-01 work well in INAV6.1 and INAV7.0 as the video: https://www.youtube.com/watch?v=bEKm-PGRnks
But when I upgraded the firmware to INAV7.1, the q…
-
### Describe the bug
Tried the 4.5 upgrade using Configurator 10.10.0 on Flywoo LR$ with FlywooF411 but unable to get SOFTSERIAL ports enabled so unable to control VTX which is using SOFTSERIAL1
###…
-
Hello, maybe I missed something. I would like to see support for this flight controller. At the moment I have a suitable firmware from Betaflight but it is for a quadcopter. And I'm building a plane .…
-
## Current Behavior
Using the new BFHDCOMPAT OSD mode with the DJI O3 Air Unit and DJI Goggles V2 set to HD display mode, the artificial horizon indicator and its sidebars at not centered, but are wa…
-
## Steps to Reproduce
1. Flash with ANY inav version (i have tried upto and including 7.1.0RC1).
2. Attach O3 AU to flight stack (correctly with battery providing power to quad)
3. No power given…
-
i need HELP i have dart with inav and when ever i enter stabilized flight mode the wings rock back and forth cant figure out help please pass through mode works just fine
version
# INAV/MATEKF41…
-
DEK uses the curious construct
```
function declaration with ARGS macro;@+@t}\6{@>
function definition without ARGS macro but K&R parameters
```
in MMIX modules `mmixal.w`, `mmix-arith.w`, `mmix-…
-
After upgrading and flashing up to BuF 3.5.0 now only motor #1 is spinning.
From time to time motor 3 will "bulb/shake" a little.
Done full chip erase while flashing via GUI, always do.
hglrc f…