-
## Current Behavior
So I decided to move from betaflight to INAV (my drone is an X8 cinelifter), everything seemed to work fine initially , but then under outputs tab in INAV when I tried to move m…
-
Please support simple version for the z25 motor controller. All inputs will work on a value of `1`.
![z25-motorcontroller](https://user-images.githubusercontent.com/198964/70601793-2893d000-1bf3-11…
-
System Setup:
Framework: ROS2_control
Motors: Industrial-grade wheel motors
Update Rate: 100 Hz
Relevant Topics:
Commanded velocities: /Nanos100_3/cmd_vel_nav/linear/x
Actual velocities: /Nano…
-
-
I tested HiTechnic Motor Controllers, and I found that the controller has a very low response time, I was doing this operation over bluetooth because I can't figure out usb connection, but I was able …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Using TMC2209 drivers on an Octopus motherboard with a full graphics smart controller. …
-
### Describe the bug
No motor is spinning in the "Reorder motors" wizard because it uses 1060 as idleThrottleValue but my motors start to spin at 1070. I have a Mobula8 Walksnail edition and i dont…
-
Either remove the pull-ups on the IN1 line on the motor controllers or add a pull-up to the IN2 line also. I actually recommend pull-ups on both, although removing is going to be simple to deal with i…
-
- Work directly with Mahika on getting this done
- we need a motor controller that works with a Linear Induction Motor
-
1st Configuration Attempt:
- connect 7.5v (5 x AA) batteries to motor controller board i.e. power circuit independent of BBB
- connect 2 x 6v DC motors to motor controller
- connect E1/M1, E2/M2 from …