-
- two pins, one for 12v raw and one for 12v ign
- diode OR together so either can power the regulator input
- 12v ign pin sets enable on regulator
-
Hi, Very nice work, thank you for your hard work.
But after I saw this, I got a little confused, it says LM5107, but the actual schematic is 2ED2304S06F, am I mistaken?
```
Version 7
---------
…
-
### Description
While doing some validation of the mini E3V2 I noticed some nasty oscillation on the hotend mosfet drain pin. At first, I though it was a bit peculiar as I just assumed the hotend…
-
There is a second version of my schematic and only one version of the software flowchart which are my final versions. Thank you!
-
I have bought a esp8266 nodemcu board, yet it is burned and smoked out when i connect 16v to Vin pin and GND to GND ? Diodes are burned as it is shown in the figure ?
I could not understand why …
-
Design PCB that can be used to fully control the scooter.
It should have:
- [x] ESP32 microcontroller
- [x] Boost converter for headlight led 5V -> 6V (1.1W)
- [x] RGB display
- [x] Power b…
-
I am referring to 'D2 - 3pin dual-diode (R5/IRQ7 to GND and R3/DAT to GND)' in the section 'Pinouts - Component List and Chipset Pin-Outs for Analog Joypad, SCPH-110' listed in PlayStation Specificati…
-
I've been testing NanoKVM with a Sipeed Lichee Pi 3A board, and I'm not sure if this is a flaw in the US…
-
I just finished testing dwdebug with a tiny13a running off the internal ~9.6Mhz oscillator. The baud rate was ~72kbps, or a bit time of 13.9uS. Using a 1n4148 diode connected to the TTL UART Tx line…
-
Several points as I went through the library.
- [ ] Some symbols have the up (D, C, etc.) and down (S, E, etc.) pins at 100mil in the X direction:
![image](https://user-images.githubusercontent.co…