-
Getting this error..
Example of my configs
[stepper_x]
step_pin: PE11
dir_pin: PE10
enable_pin: !PE9
microsteps: 16
rotation_distance: 40
endstop_pin: PB14 # PA1 for X-max
position_endst…
-
Hi I tried to connect 4 **TMC5160** in daisy chain. However I could not get the motor moving. There seems to be a **SPI problem** with the TMC5160s. I have also _grounded_ the CLK pin
However I'm …
-
### Wiki Search Terms
http://wiki.fluidnc.com/en/hardware/3rd-party/MKS_DLC32
### Controller Board
MKS DLC32 V2.1
### Machine Description
H-Bot and Servo (Z)
### Input Circuits
_N…
-
I have a working zephyr project running on **nucleo_u575zi_q** board and I'm trying to use the zephyr-trinamic inside my project.
After making the following changes in my project I'm getting a buil…
-
https://github.com/trinamic/TMC-API/blob/3da0cec86d2f14c3f1b6f29950df6fe2cc41624b/tmc/ic/TMC5160/TMC5160.c#L53
Sometimes when reading a spi value the upper 16 bits are all 1's. I noticed this line…
-
### Is your feature request related to a problem? Please describe.
_No response_
### Are you looking for hardware support?
tmc5160 hv drivers
fysetc spider v2.2 board
### Describe the feature you…
-
Hi. is possible use TMC2130/TMC5160 in SPI mode?
greetigs
-
Hi, i am using 4 motors for Z axis (Nema23)
and i am using TMC5160 v1.2 for all 9 drivers and with 128 microstep
TMC5160 is capable of 4.5Amp, and My NEMA23 motors are 4A/phase
after starting 5 min…
-
Issue:
The SPI bus cannot communicate with the “TMC5160 PRO” driver.
Notes:
• STEP/DIR work.
• Not able to communicate with SPI
• Tested two TMC5160 PRO drivers with the same result.
• Octopus…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
Stepper motors are noisy/vibrate at low, medium and high speeds (30mm/s, 60mm/s, 80mm/s, 120mm…