-
I was wondering whether it was a good idea to append the node id to the self-generated nicknames created by the user? If I have deployed a bunch of nodes I may know the node ID and the location of tho…
samuk updated
3 years ago
-
Greetings.
I ran examples/AXP192.ino on my TTGO T-Beam v1.1, and the device turned off and could not be programmed. The example sketch puts the device in an unbootable state.
I recovered the dev…
-
Hello,
i am unable to compile version 3.6.2 for heltec esp32-s3 v3.1 hardware. I try all 3 possible options in platfomio.ini
halfile = ttgotdongles3.h
;halfile = ttgotdongledisplays3.h
;halfi…
-
Hello.
Maybe I did stupid things...
I ordered a T-beam ttgo motherboard (T22_V11-2019.1212) with Meshtastic software on it.
I uploaded an esp-32-ogn software that I used before, but I didn't se…
-
Hi,
I use Heltec Lora 32 v2 with Oled.
I tried it with LiPo and Li-ion batteries but the display show 0% and ~0.3V (+00.0mV/min).
The device runs on battery well and charges from usb.
Thanks!
-
Quite all in the title : T-Beam V1.1 433MHz Doesn'twork as T-beam but as TTGOv2
Using uploader, work fine until Wifi link
As T-Beam :
The T-beam is unable to link the Wifi network and ask to get b…
fr4sw updated
6 months ago
-
1. Stratux version:eu27
2. Stratux config: 978 and 1090 RTL-SDR
YES GPS
NO 978 Mhz (UAT)
YES 1090 Mhz (ADS-B/Mode-S ES)
YES 868 Mhz (OGN)
NO 162 MHz (AIS)
YES AHRS Sensor
YES Baro Sensor
…
-
I'm not sure where exactly to report this, as it can more than likely be a hardware issue. But making a note here for reference.
While cleaning up TTN Mapper data I stumbled on a pattern where Cube…
-
End user devices cannot join network with sample code. I tried two different gateways: ChirpStack and RAK7268V2 connecting to TTN. I see the join acks coming back from the gateway, and it should be …
-
Dear Pawel,
I have just installed you OGN-tracker to work with my Stratux on a T-BEAM and that works fine from firmware.binary coming from new Stratux eu022.
I have then compiled the firmware with …