-
**Describe the bug**
When both devices(ant usb via ch340 and Original victron rs485 to read et340) are connected none of them is working.
**To Reproduce**
Steps to reproduce the behavior:
1. Con…
-
**VenusOS (please complete the following information):**
- Device type: RPi 3B+
- Firmware Version: 2.89
**Battery/BMS (please complete the following information):**
- BMS/Battery type: JK B1…
-
**Describe the bug**
0.11beta1 reads wrong cell voltage
The fill level, the total voltage and the current [A] are read out correctly, only the minimum and maximum cell voltage in the detail page i…
-
**Describe the bug**
@4000000061d721bc1b35b89c *** starting serial-starter ***
@4000000061d721bd0653fccc find: /service/dbus-serialbattery/service/service/service/.../service/: **Too many levels of …
-
altered wiring on the current monitor, so reset to 100%
battery was actually at 75% at the time.
Now charging at circa 11-12A using solar and monitoring through VenusOS.
SoC reported went up to 105…
-
Hi,
I would like to add two Epever MPPT charge controllers to VenusOS via RS485.
I ask because there are now many drivers for other hardware and I could not find anything ready.
I can read out th…
-
**Describe the bug**
I don't know if this is a bug, it seems "/Alarms/HighCellVoltage" is never updated since function dbushelper::publish_dbus()
never published this entry.
!! OK forget …
-
**Describe the bug**
When this driver is installed into Venus OS and instead of serial BMS I connect Victron Smartshunt witch VE direct to USB cable, it is recognized correctly, but after Venus resta…
-
**Describe the bug**
A clear and concise description of what the bug is.
Script find wrong BMS have JKBMS found sinowelth
**To Reproduce**
Steps to reproduce the behavior:
1. extract tar file…
-
We need to try a WebAssembly build of the UI, and test it in various browsers.
Eventually, we need to switch from DBus to MQTT for the data model integration, but that can come later...
First step i…