-
The UI should deal in percent servo travel. See BLDC_PWMDC_Set(). The input should be percent of servo travel, which will convert to PWM period (see PWM_X_PCNT() macro). The servo travel needs to be …
-
As reported here:
https://community.simplefoc.com/t/sensor-as5047p-spi-reads-0-angle-with-stm32f103-aka-blue-pill/886/18
but also by other users, I think. It explains the difficulties some people …
-
hello Emanuel i want to use your model and the model init give me this error with a missing file and i have a question can i mdify this work to be able two run on another hub motor with a 17inch 48v …
-
I want to adapt this for 2 to 5 hp motor.
I am planning to develop a solar powered BLDC motor pump without using any batteries.
SOPV + MPPT tracking + BLDV driver-> BLDC Motor.
What changes nee…
-
Hello! I would like to preface this issue by saying you guys are doing some amazing work (and have been for a long while)! I have used many projects that use JSBSIM as a backend and now I would like t…
-
Hello. I have done some test on this yukminglaw repo before but i was getting too much noise on ffb motor. I have tried some pwm codes but didnt succeed. Would you add a template about it on your repo…
-
In the non-energized winding of the BLDC motor, the current is zero and the voltage measured is
the BEMF of the motor. Some good explanations of this are found in ST publication [AN1946](https://www…
-
## Environment
- Development Kit: ESP32-DevKitC
- Kit version: DevKitC
- Module or chip used: ESP32
- IDF version: 4.0.1
- Build System: CMake
- Compiler version: 8.2.0
- Operating System: Li…
-
As mentioned in the title.
Many commercial BLDC ESCs produce a start-up tune.
Have anyone tried this on VESC? Would like to know more on this.
Probably will implement it once figured out.
…
-
I am building a CNC/portal robot based on a home-built BLDC linear motor controlled by ODrive. Currently I interface the ODrive with a GRBL controller using step-dir mode to implement motion control f…