-
Opening an issue for discussing the creation of an MRE that use EonTI certificates instead of the current self-signed certificates.
-
Hello Kris,
I have implemented your code for 9250 with STM32F401 MCU.
The problem that I have is when sensor is flat and still, the calculated Q values are changing at a constant speed (big drifting…
-
Hey there,
I really like the useful markers over every trader. Unfortunately the mod causes for MC 1.19.3 Forge 44.1.5. a wired issue when using a ressource pack.
Starting MC without an aktivate…
-
Due to the fact that we have another issue that has had a number of OT comments I think it might be good to have a new mostly OT thread here rather than clutter the one in the other repo more or the i…
-
### The problem
Hello
I'm trying to use the Volvo integration. It doesn't work for me. When i'm reading the api documentation there is a OAuth 2.0 authorization with tokens. The only thing you ca…
-
This ticket is to contain the work/discussion stemming from a [telegram discussion](https://t.me/acc_group/82451).
**As-is:**
If both `rc` (resume_capacity) and `rt` (resume_temp) with the `r` po…
-
### Describe the bug
Netzladen funktioniert nicht. Er macht zwar ein "set battery mode: charge", aber das wars dann auch. Ich verwende einen Kostal Plenticore Plus 5.5 G1, ein KSEM G2 und einen BYD H…
-
I installed from an SD card and copied the installation to eMMC, but the board refuses to boot from eMMC unless I hold `RESET` upon power up.
There's no 'mtd' device, so installing uBoot to the SPI…
-
Any way to retrieve battery level and charging status for the Prius Prime and RAV4 Prime PHEVs? Would be very useful for automations in HomeAssistant to make sure the car is plugged in.
-
### Describe the bug
After updating from 0.124.4 to 0.124.7 I cannot connect to my Huawei SmartLogger any longer as I am getting a modbus Error along the lines of "pv 1 power: read failed: modbus: ex…