-
```
What steps will reproduce the problem?
1. If I plug in the OSD and copter without a link to APM Planner 2.0
2.
3.
What is the expected output? What do you see instead?
I expect to see my loc…
-
Idea is when mission is to long, and when copter battery failsafe trigger RTL, copter land and we reset it changing battery, it would be great to set new start waypoint from mp, without remake flight …
-
This causes QGC to not be able to load heli firmwares on all boards. I'm not sure if it is just "OFFICIAL" versions which are incorrect. But those are the only entries which QGC uses for now.
Here …
-
## Bug report
**Issue details**
Flashing the firmware on Pixhawk (CubeOrange) with different default parameters (rfnd, batt_monitor, ATC params set) results in some of these parameters not getti…
-
using copper tape on bottom of GPS mount. could also be al foil. aspirin or vitamin?
https://ardupilot.org/copter/docs/common-compass-setup-advanced.html#compassmot-compensation-for-interference-…
-
Copter's precision landing assumes that we the camera is hard mounted to the bottom of the vehicle. At least one users has requested that we support the hardware setup where the camera is mounted on …
-
```
What steps will reproduce the problem?
1. power on the rc transmitter and copter.
2. Now there is osd overlay, but the data is not beeing updated. Everyting at 0.
3. Arm the copter. Data appears. …
-
```
What steps will reproduce the problem?
1. power on the rc transmitter and copter.
2. Now there is osd overlay, but the data is not beeing updated. Everyting at 0.
3. Arm the copter. Data appears. …
-
```
What steps will reproduce the problem?
1. power on the rc transmitter and copter.
2. Now there is osd overlay, but the data is not beeing updated. Everyting at 0.
3. Arm the copter. Data appears. …
-
```
What steps will reproduce the problem?
1. power on the rc transmitter and copter.
2. Now there is osd overlay, but the data is not beeing updated. Everyting at 0.
3. Arm the copter. Data appears. …