-
I think it's time to think about designing a FC specifically for INAV.
Features I want to have on this FC:
1. Future-proof design with an F4 (or even F7) CPU
2. 8 outputs supporting 8/0, 6/2, 2/6 mo…
-
I rebased Triflight on top of 1.14.0, but I noticed that the CPU load is too high by default.
I then tested with stock CF 1.14, the situation is same there. I'm testing on RCEXPLORERF3 target.
B…
-
Hi, I am new to the Naze controller, so hopefully it is an easy fix that I have happened to overlook.
I recently bought a naze32 to upgrade from my old cc3d. I had it working fairly well and was doi…
-
It apparently works well.
boris says: `Btw the latest filters solved all MPU6500 issues i case you didnt know`
http://www.propwashed.com/notch-filter-practical-guide/
hydra updated
8 years ago
-
Allow gyroscope to be sampled and filtered faster than PID loop makes corrections.
Settings:
`gyro_lpf` will define built-in filtering
`gyro_rate` will define gyro sampling rate. Possible settings 50…
-
There are regression in 1.7. 1.6.1 was not affected this.
Inav 1.7 RC
Sparky 2
dsmx satellite
On rc failsafe recovery a plane becomes uncontrollable and just falls to the ground. This happens …
-
Just got the above flight controller and connected it to Clean Flight Configurator. It came with 1.10.0 firmware and only showed Gyro, Accel & Baro as green... the mag is not detected.
From CLI I ran…
-
It seems to me it would be useful to have a single place to record incremental test successes (and failures) on the road to next release. It may also help catch regressions. If you disagree, please cl…
-
Got my hands on a Sparky 2.0 and wanted to give it a go with BetaFlight. The Accelerometer indicator is not working so I can't calibrate the board.
-
With the move to the MPU9250, and the potential for high rate reading. The need for a large isolation system is reduced.
Some form of mechanical and thermal isolation is still needed, but we should co…