-
my apologies if this already has been asked and answered.
working on the osd code, i've noticed that every time i reboot the fc, for a few seconds after bootup, the `averageSystemLoadPercent` goes in…
-
In chat it was suggested i make a PR for this, forgot that i already have a GH account, and now decided to open an issue instead.
When there are vibrations picked up by the ACC, in 1.14.1 (and 1.14…
-
First, I would like to apologize as this problem is entirely self created :( I used Sparky 1 Schematics to make a board for a tiny drone I am building. The schematics are mostly identical except I rep…
x0054 updated
8 years ago
-
Hi@all,
Im tested my new build quad and notice a nasty noise. This noise is unsteady and comes often if the quad is speeding or pitch pumping. I start with logging the flights with blackbox and not…
-
Thanks for the project and nice tutorial!
When I run the project I see only a white screen. Any ideas?
Thanks
-
I've been working on F7 (and stm cube hal driver) support. I now reached a point to catch up with the master. I'll have to do some work on the merge so that might be a good opportunity to fix some u…
-
This is not new to 3.0.0, 2.9.0 had it also. Haven't checked previous versions.
MAG is detected on CF and INAV on the same board.
gaelj updated
8 years ago
-
No serial port detected after flashing to 3.0. Flash back to 2.9.1 works fine again.
DaTwo updated
8 years ago
-
Some support for F4 is done by @sambas already, it has to be ported to iNav
-
When I turn my TX off Failsafe Stage 1 gets triggered and works perfect but no matter what I do Failsafe Stage 2 never engages. I tried making a "Failsafe" mode switch and I still cant get Stage 2 to …