-
How many amps can the heater outputs handle?
Can I run both 50W heaters on out output or should I run them on seperate heater outputs?
-
I've seen this:
https://www.biqu.equipment/products/bigtreetech-s42a-42-stepper-motor-closed-loop-driver-board-with-oled-display?variant=31362657517666
And the stepper drivers it comes with has an…
-
Currently, I have a LED ring light that I have in my 3d print enclosure that's doing a good job, but it's not capable of being remotely turned on or off.
Will want to add the ability to have this i…
-
I have a question on whether or not I can connect a filament sensor to extra pins on my board.
I am using the tap mod so those pins and the x-limit switch is taken. I saw another post with a 2209 …
-
Hey again! Firstly I just wanted to say thank you for the work you've done on the project thus far; there is nothing else like this out there and I hope you continue to develop and refine it. I hope m…
-
Good day.
I can get the cb1 to boot but the firmware.bin is never picked up by the sdcard reader. I've tried DFU mode but it always errors out:
`biqu@BTT-CB1:~/klipper$ sudo dfu-util -a 0 -D ~/…
-
Is not possible to configure Marlin with this driver, everything looks like OK, but you'll always get the error "TMC communication Error"
![Captura1](https://user-images.githubusercontent.com/45154…
-
I have a problem where the jumpers for the DIAG pins to run sensorless homing, have no connection to the pin of the endstop.
Is the H729 a newer version???
-
I have just finished a rebuild of my printer. I am using the V1.4 Turbo from BTT with 2209 sensorless settings. I have got things compiled and have run into an issue. I have an early Bltouch 3.0 (got …
-
im trying to install a bl touch 3.1 and its not working at all i have defined 5v in the firmware and im not getting 5v on the pin on the zprobe