-
I have VS Code installed but I am beyond newb with VS in general. How do you run this, shouldn't there be a launch.json file? Happy to help documenting in the wiki if I can build/run this. I'm also…
-
New thread.....
-
I am fairly new to ODrive. I want to increase the maximum current limit that passes through my motor. I tried to use below python code but didn't succeed:
```
my_drive.axis0.motor.config.requested…
-
Hi everyone,
I want to use Multi threading on both cores of the ESP32
and 2 examples I found work fine for me:
1: https://www.hackster.io/rayburne/esp32-in-love-with-both-cores-8dd948
2: https:…
-
Greetings,
I propose that we remove the voltage-sense networks from the output of each of the BLDC output nodes (A/B/C). Reasoning:
* BLDC phase voltage-sense data is only useful when a motor is …
-
Hello,
I'm using the USART2 control type (Using a Raspberry pi 3 with a usb-to-serial),
so far I can communicate with the board but the motors don't spin, they just make an high frequency noise. I…
-
I've gone to every website to get this VESC tool because I think it will help me get my electric longboard running but I can't seem to find anything other than this source code. I have it extracted bu…
-
Hi, in line 259 in file BLDC.c is a type, the accerage current will always be for the Left motor even when you try to read motor[1]
> electrical_measurements.motors[0].dcAmpsAvgAcc += ABS(adc_buf…
-
Can g2core run on Teensy 3.2? If so where could I find build instructions?
If not, what would it take to make it happen?
Thanks,
Travis
-
I felt like I had to leave a warning somewhere ;)
When using the machine protocol with USART2 and USART3, the main routine crashes pretty often for me.
That's also the reason why I'm not actively …