-
After running the mbed-hal-rtc-reset test, something really bad happens to the DAPLink debugger and/or the Redlink debug tool on this target. The board is unable to be programmed anymore, and is tota…
-
Hi
I want to connect CX20924 EVK on x86 system.
According to CX20924 EVK SPEC Page 4 (https://www.synaptics.com/sites/default/files/audiosmart-4mic-dev-kit-product-brief.pdf)
CX20924 EVK needs I2S…
-
### Description of the problem
The issue is described in:
https://mne.discourse.group/t/converting-gradiometers-to-virtual-magnetometers-for-neuromag-122/7056/6?u=dasdiptyajit
In short:
Duri…
-
We have a RT1050_EVB board with QSPI flash boot enabled.
DAPLink firmware compiled out within this ARMmbed/DAPLink isn't working.
I have tried all below three, none of them works for me.
1.…
-
Hi ,
First of all thank you for the great work. I am trying to build the **bridge** application for target **freertos_rt1189_cm33** .
I am working with NXP MIMXRT1180-EVK board.
I have setup e…
Sinai updated
1 month ago
-
https://github.com/au-ts/sddf/pull/157 adds initial support for the i.MX8 based MMC block device.
The main motivation for this is to support experimentation regarding hot-plugging and so we do not …
-
https://www.u-blox.com/en/product/evk-bmd-3035#tab-documentation-resources
-
Hello,
I believe that I am missing some key documentation here. I installed the OpenWRT Image, and booted the EVK. I've logged in and followed the extremely limited steps in the .PDF linked to in…
-
Hi everyone,
I'm trying to use ICU-10201 sensor without the EVK board. I implemented a specific hardware using a 1.8v regulator as explained in a previous issue. However, I can't make it work. The …
-
The NXP MCUXpresso SDK v2.15 updated the Flash Control Block (FCB) used for the MIMXRT1170-EVK board . These changes to the flash boot settings have broken pyOCD support for this board now. If an ap…