-
Hi, recently I'm on a project to connect multiple Target FPGAs to a Microzed 7010 motherboard. I have successfully implemented One Single daughter board following "XAPP1251 (v1.0) April 30, 2015". How…
-
The `pmod` operation is one of many examples that can easily be defined in Cryptol but could benefit from being a special case (especially for performance during concrete execution).
It would be us…
atomb updated
3 years ago
-
The `\pod, \mod, \bmod` and `\pmod` commands are not supported.
- `\pod` is a command to indicate a congruence relationship displaying the modulus in parentheses, separated from the left sibling by a …
arnog updated
4 years ago
-
I am using a PMOD ESP32 : https://digilent.com/reference/pmod/pmodesp32/reference-manual
I have connected it to the Go board FPGA : https://www.nandland.com/goboard/introduction.html
My setup is l…
ghost updated
2 years ago
-
### 現象
- zybo-z7-10-pmods-petalinux.bit.bin
- zybo-z7-10-pmods-petalinux.dtbo
を以下の手順で読み込むと Bitstream, dtbo のロードは成功し、 GPIO として使えるようになるが
```
cdns-i2c e0004000.i2c: timeout waiting on completi…
-
**Describe the bug**
`pmod` when done with decimal values on a precision of 38 can produce incorrect answers. if the numbers are negative and large.
**Steps/Code to reproduce bug**
a=Decimal('…
-
I'll start the first one:
In my attempt to debug WaitForRisingEdge by passing in a debug LED I now receive the following error message:
```
^^^^^^^^^^^^^^^^^^^ incorrect input parameters in call …
-
```
What steps will reproduce the problem?
1. Install Caudium
2. Wait the cache to be sufficiently populated
3. See the error 500 from the cache coming
What is the expected output? What do you see i…
-
```
What steps will reproduce the problem?
1. Install Caudium
2. Wait the cache to be sufficiently populated
3. See the error 500 from the cache coming
What is the expected output? What do you see i…
-
What worked for me was to set it this way:
```haskell
let modTarget = superdirtTarget {oName = "SuperDirtMod", oAddress = "127.0.0.1", oPort = 57130 }
oscSet = OSC "/set" $ Named {required =…