-
Rerap 2 and 3 firmware configuration data missing.
-
Hello good afternoon,
I am writing to you because I have several failures or problems with the products that I have acquired from your signature on aliexpress and they do not know how to respond.
…
-
i run de last firmware 0.83
Ramps 1.4
Reprap Prusa
when the printer start to hit endstop mini. everytinh works grate but whene Z gos to start position so the extruder can heat up. the right motor just…
-
### Version
PrusaSlicer 2.4.0-rc2+win64
### Operating system type + version
Windows 10
### 3D printer brand / version + firmware version (if known)
Custom Toolchanger, RRF 3.4 beta 7
### B…
-
Hi, I have been very unsuccessful on adding either an ESP8266 S-12 or a 3dMellow ESP32 module to my SKR2.0 vB boards. What is needed to prepare the wifi modules for use? If I just plug them into th…
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …
-
I was wondering if it would be possible to use this firmware with these electronics:
http://reprap.org/wiki/Duet
It is a Due based board, but I cannot tell if it would only require and new pinout, or…
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …
-
```
What steps will reproduce the problem?
Uploading bootloader for 644/1284 with Arduino IDE using the provided
boards.txt.
What is the expected output? What do you see instead?
I have an Sanguino …