-
I've read through some of the prior requests for SAM4S Compatibility. If anyone would like to tackle this functionality, I can act as a direct resource. (I am an M3D Engineer, co-developed the Duet M…
-
Just showing interest for a particular family i use, and cortex-m7 support in general (no rush)
https://www.microchip.com/en-us/product/ATSAMS70N19
Dev boards for this are few, expensive, and pr…
-
**Describe the bug**
When a user use `mcumgr-cli` to upload a new file to the device, the upload may stuck in the middle of uploading.
**To Reproduce**
Steps to reproduce the behavior:
1. west b…
-
I'm trying to configure an NPN Inductive Sensor and, according to the [documentation](https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe) I should be connecting the probe's signal to `Z_PROBE_IN`, an…
-
I have been through the list of Pins at the top of the Duet-Duex config file and am unable to see any reference to temps for the MCU and Steppers, as I would like to view them on MainSail.
RRF uses '…
-
Ok not really sure if it's spose to be an issue or a request? Anyways, here goes.
From what I understand the Duet 2 line is supported by klipper as of now.
I haven't really been able to dig up t…
-
Finally got back to install klipper on maestro, but then this happened.
I've tried several versions Buster and similar, the normal installation of klipper and DWC, and the manu7irls combined script…
-
Thanks for the nice library.
There is one question.
How to send Russian characters for printing?
If you write a text in Russian, incomprehensible characters come out, apparently a conversion is nee…
-
Hello.
i have a skr v1.3 and i can´t load the firmware over. i have tried both via the installer and taking the .bin file and putting it on the sd card. if i put it on the sd card it just stalls. li…
-
The data sheet only document three 4S variants. The missing variants are the SAM4SDx.