-
### Bug Description
There are vertical lines on the printed part. It's best described as the beginning of corners(ringing), but in my case, it's the same along the whole x-y axes - in case of a c…
-
### Description
I just installed TMC5160 on E0 and tried to compile firmware. It did without errors, but it's not working. When I changed E0 to TMC2130 in code, it says I don't have CS E0 pin d…
-
Hi,
If my board skr e3 dip v1.0 has 3 tmc2208 uart installed and 1 tmc5160 spi.. what should i do? can i use uart mode at tmc 2208 same time spi also enabled at tmc5160
-
hi. im using tmc5160s from bigtree, their version v1.0. i was keeping them for a project and today i tried install them on my skr v1.3, i got connection error. i tried them while marlin 2 still in be…
-
### Description
Printer is Tronxy X5S retrofitted with 24v supply and RADDS running 2.0-bugfixes pulled from git earlier today.
Have been using watterott tmc2130 w/ hardware spi implemented by so…
-
I'm having trouble connecting TMC 5160s to SKR 1.3 board. When I power up the board I see "3d printer ready" message for 2-3 seconds which then changes to "driver error, printer halted, please reset".…
-
### Bug Description
My part cooling fan is set to start cooling from layer 3. As soon as fan start spinning my extruder [e3d hemera] stops extruding, even the gcode is being send.
I disabled f…
-
Hi,
I got TMC5160 v1.2 from BIGTECHTREE.
Board: SKR v1.3
Marlin 2.0
Im trying to apply tmc5160 on asix y configure all and still it doesnt work.
I figure it out that comend M122 there are some …
-
I'm having a problem where seemingly randomly the motor will basically die out. The RMS voltage slowly climbs but the motor won't run. To get it to run again I have to power off both the board and…
-
### Description
I'm using 5 TMC5160 V1.2 (BIGTREETECH) on my SKR v1.3.
At boot after a few seconds I get the "Driver Error PRINTER HALTED please reset" error message.
### Steps to Reproduce
…