-
```
What steps will reproduce the problem?
1.When changing the stick mode (RETA to another one, mode 1 to 4).
2.At power on, if mode 3, the throttle stick is not at right place.
3.Receiver channels no…
-
```
What steps will reproduce the problem?
1.When changing the stick mode (RETA to another one, mode 1 to 4).
2.At power on, if mode 3, the throttle stick is not at right place.
3.Receiver channels no…
-
```
What steps will reproduce the problem?
1.When changing the stick mode (RETA to another one, mode 1 to 4).
2.At power on, if mode 3, the throttle stick is not at right place.
3.Receiver channels no…
-
**All:**
I've been busy working on fixing Grbl's state machine and need to get an idea of usage of the auto_start setting. Does anyone disable this auto_start setting? If so, can you give a descripti…
-
I need some help with some quality images team. Here is what I need
*The switch set to on, on the alamode so you can power both pi and alamode
*Someones alamode that has multiple flow meters setup o…
-
As work begins on the new chassis and electric component layouts we need to make sure all the wires in the wiring harness are labeled.
-
If we install all of the electronics (except for the battery) on removable boards (e.g., plexiglass), then the electronics can be assembled on a workbench before the mechanical work has been completed…
-
Create a formal wiring schematic in multisim and an assembly drawing of the robot wiring as well as updating robotmap.h to reflect all of the robot I/O.
-
All of the electronics on a robot (except for the battery) should be installed on a board pre-sized correctly to fit into the mechanical chassis, so that:
- the electrical components and wiring can be…
-
If we install all of the electronics (except for the battery) on removable boards (e.g., plexiglass), then the electronics can be assembled on a workbench before the mechanical work has been completed…