-
Steps to reproduce:
1. Open http://www.ti.com/lit/ug/swru209b/swru209b.pdf. Notice that the page is centered.
2. Zoom to 350%.
3. Switch back to automatic zoom.
4. Notice that the page is off-center.
…
-
Hello,
I test Sonoff ZBR3 with your first release firmare with temperature sensor DS18b20.
I use this relay for control electric heater in water tank.
In HA with mqtt i see temperature from sens…
-
```
您好,
感谢西北工业大学无线传感网的相关工作人员,同时也感谢您们的开源精神!
请问如下几个在CC2420下使用的components,在移植后CC2530文件中那些函数与之相对应?
components CC2420PacketC
command uint8_t getLqi(message_t *p_msg)
command uint8_t getPower(m…
-
**Describe the problem you have/What new integration you would like**
Please consider making ESPHome firmware as a Zigbee to MQTT bridge/gateway on hardware like ITead Sonoff Zigbee Bridge (S…
-
# Generic APP
宏定义配置在下面,这里的修改都保存在`.ewp`文件中。
![image](https://user-images.githubusercontent.com/78364027/233841989-5b62352a-94b7-46c9-97d6-ce75aeb53e20.png)
## 工程介绍
- Accessories:这个文件夹包含了一些附加组件,例如 O…
-
Hi,
Both Domoticz, Node-Red and Zigbee2MQTT are running on an RPi3b (Stretch)
When "Zigbee2MQTT Admin Panel" flow is running, the Domoticz log receives continuously (each 4 seconds) messages from …
-
### What happened?
Upon sending payload `{"color_temp": "warmest"}` to the /set topic of a HG06492A bulb, I get the following error:
`{"message":"Publish 'set' 'color_temp' to 'ledbulb' failed: 'Err…
-
I have a modified ZBMini with this configuration:
![image](https://github.com/ptvoinfo/zigbee-configurable-firmware/assets/42682043/80083aa0-f559-4a45-8506-8d7ccf2075c9)
Input 2 is linked to Out…
-
Can zigpy-cc support CC2538 / CC2538x chips by Texas Instruments if use Z-Stack 3 based firmware?
CC2538 (in combination with CC2592 amplifier) will reportedly be much better than CC2531
For ref…
-
Hi. I have a [XL2530-D01 module (based CC2530 F256)](https://www.amazon.co.uk/2-4GHz-CC2530F256-Wireless-Communication-Evaluation/dp/B00M9ZKMCA)
I connect the module to the Arduino as follows
![wi…