-
- Add a settings menu option to play sounds/music from the SD card if mp3 files are detected.
- Set a sound to play if a GPIO is pulled high. 13 and 14 have headers on the control board.
-
As the title says, I have a board version 1.4 rev 3, but according to the firmware and documentation, I can *only* use a Jameco 157041: https://github.com/CircuitSetup/Split-Single-Phase-Energy-Meter/…
-
**Operating environment/Installation (Hass.io/Docker/pip/etc.):**
Docker/hassio in Ubuntu X86
**ESP (ESP32/ESP8266, Board/Sonoff):**
NodeMCU ESP32
expressif ESP32-WROOM-32D
Tried wit…
-
I use the counter with the ES32 , I have a problem with the power factor sometimes for loads I have the right value, sometimes for other loads I have a lower value !!!
for example i should have 0.98 …
-
I've got one Main Board with two Addon boards stacked on top. All are working fine, with the exception of Addon 1 CT8 (middle left).
The CT Clamp is clamped to monitor an Air Conditioner. With 18 Amp…
-
# Bug Report
Hybrid E-Wand CP180335E getting error "Failed to interview" when paired
## What happened
E-Wand joined OK but does not complete interview process.
Failed to interview '0x588e8…
-
Wanted to try logging to the serial monitor, so trying to compile the esp code using platformio. Is this what you are using @CircuitSetup ? Or the Arduino platform? As per the readme, I pulled the cod…
-
the device either does not recognize the SD card or the web portal is not recognizing the content.
Unable to load sounds via the enter key command instructed either.
unable to save settings in the w…
-
Hi!
Two weeks ago I received a CircuitSetup Split Single-phase Energy Meter with two transformers 2x 16 mm round YHDC SCT-016 120 A CT Sensors.
I can’t calibrate Energy Meter for a long time.
Throu…
-
## What happened
New Install just a few devices and last seen of the bulbs is not being reported.
Availability is set to 60. last seen did prev work in HA on a ZHA with the same devices.
## What d…