-
I am struggling for a couple of days already and cannot get ebusd to load the proper csv files. I have tried downloading them over the web with --configpath=http://ebusd.eu/config or by putting them i…
-
Hi is there a possibility to tchange the water Heating mode from Normal to Eco via homeassistant/mqtt?
currently i am unable to read/write the according property. I would like to switch the water hea…
-
Do we have any updates to this driver to the more recent platforms? Specifically running ROS Kinetic, Ubuntu 16.04, and eBUS SDK 5.1?
-
Bonjour,
J'ai un souci pour extraire des valeurs de messages de type JSON avec JMQTT:
Ma config: Jeedom 4.1.20, JMQTT 2020-02-18 01:42:45
J'utilise ebusd pour le monitoring et le contrôle de ma…
-
### Description
I use tado as room thermostat.
When I start ebusd HA Addon, the values I specified with priority 1 in the bai file (Flame / WaterPressure) where synced every 2 seconds like I config…
-
My esp-ebus-adapter sometimes becomes unavailable and does not come up again. From other projects I know that the low-level IP stack of esp sometimes can make problems and requires a full reboot to be…
-
I have a problem because the controller reset my Vaillant VRC630 calorMatic when I connect it, connect ESP and when I send a telegram.
In an idle situation without ESP connected after the green led …
-
Hello,
I'm in the process of integrating my Wolf WPM-1 heat pump into Home Assistant running on a Raspberry Pi 4 with an eBus v5 adapter connected via GPIO. The connection seems to work and `ebusct…
-
When using e.g. VR32 for connecting one eBUS to another and providing access to a single device in the second bus on a dedicated address on the first bus, the communication timing is no longer specifi…
-
And the front end continuously asks me for a username when I try to send a message.
```
=ERROR REPORT==== 11-Mar-2017::12:55:03 ===
Ranch listener http had connection process started with cowboy_…