-
Hi.
Iam use the U-Blox version ZED-F9P. it has the only format RTCM3.3. Will further the conversion of 3.3-> 3.2?
-
Would be great to support the survey in mode of the ZED-F9P for those looking to use this as a more temporary local correction source (eg on site with a drone). Having the ability to trigger that with…
-
#### Issue details
I have a Pixhawk 4 when connected with a USB cable directly to my computer mission planner gives a value of horizontal accuracy / gpsh_acc (usually around 0.9 to 1.5 outside) but w…
-
Does anyone have a **ROS driver for ZED-F9R?** Because I want to get **GNSS and IMU data** of F9R in ROS environment. However, I can't find any ROS drivers for F9R on Google so far, all the informatio…
-
I was trying to get ZED-F9R IMU data published in the form of a sensor_msgs/imu message. Currently, I am using a zed-f9p config file that can be found below.
```
# Configuration Settings for zed-…
-
I have created a ubx file by using u-center with ZED-F9P.
I just want to extract information from .ubx file created by u-center.
Am I able to do that with this repo?
-
This project has so far been really bad about handling different versions of the protocol. For examples, see #33 and #24. The goal of this project is to support "all" versions of the protocol, but so …
-
When using the dual gps heading with two ZED-F9P without connection of UART2 each other, all serial is breaked. So I tried to find someting about that, but I couldn't find that. Most of user use GPS_U…
-
Hi,
I am using a ublox C099-F9P for my rover and a NTRIP base station.
I am quite new to the whole GNSS topic so i wondered if my settings are correct.
Input 1 is set to serial and "ubx" format…
-
Trimble rovers needs 1008 message.
Where the best place for message injection?
1008 message should go after 1005 or 1006 message.
Also, for GLONASS corrections support, 1230 message need correcti…
d1ken updated
3 years ago